Description
THE FLANGER GETS A FACE-LIFT
Building on the 20-year legacy of the famous BOSS BF-2, the new BF-3 flanger pedal gives guitarists and bassists an updated version of the classic BOSS flanger with the thickest stereo flanging sounds ever. Two new modes (Ultra and Gate/Pan) create stereo flanging with incredible depth--even Slicer-type effects and sounds that seem to "swirl" around the listener. An instant classic.
- BOSS' best flanging effects in a compact pedal
- New Ultra and Gate/Pan modes for ultra-fat flanging and futuristic slicer-type sounds, respectively
- Momentary mode turns flanging on instantly
- Tap tempo adjustable via pedal
- Independent Guitar and Bass inputs and stereo outputs
FREQUENTLY ASKED QUESTIONS
1. What does the BOSS BF-3 pedal do?
- The BOSS BF-3 is a flanger pedal that splits the signal into two. The duplicate audio is played at a lower speed than the original. It creates a “whooshing” chorus sound. It has four flanger modes. It also has knobs that let you control 5 different settings. It is one of the most complete modulation pedals out there!
2. Is the BOSS BF-3 easy to use?
- Yes. The BOSS BF-3 is very easy to use.
3. Is the BOSS BF-3 analog?
- No. The BOSS BF-3 has a digital circuit.
4. Does the BOSS BF-3 require a battery?
- Yes. The BOSS BF-3 uses a 9v battery.
5. What country is the BOSS BF-3 made in?
6. What is the difference between the BOSS BF-3 and the BF-2?
-
BOSS BF-3
- Separate inputs for the bass and guitar
- Stereo outputs
- More Flange modes
- Digital
-
BOSS BF-2
- Only one input for the bass and guitar
- Simpler modes
- Analog
7. Where should the BOSS BF-3 go in the signal chain?
- The BOSS BF-3 is a flanger pedal, it is usually placed toward the back of the signal chain.
8. Can I use the BOSS BF-3 as a tremolo effect pedal?
- Yes. The BOSS BF-3 has a gate/pan mode that can create a tremolo effect. You can also control the knobs to get your desired sound.
9. Does BOSS BF-3 lose some of the low ends on the bass?
- No. There isn’t any noticeable loss on the low ends.
10. Is the BOSS BF-3 a true bypass pedal?
- No. The BOSS BF-3 is a buffered pedal.
11. Can I connect the two outputs simultaneously to two different pedals?
- No. The cables would have to loop back to the chain.
12. Does the BOSS BF-3 still affect the signal when it is turned off?
- Yes, to some degree. The BOSS BF-3 is not a true bypass pedal so it still might affect the signal.
13. Does the BOSS BF-3 work with bass?
- Yes. The BOSS BF-3 has a separate input for the bass
Specifications
- Nominal Input Level: -20 dBu
- Input Impedance: 1 M ohm
- Nominal Output Level: -20 dBu
- Output Impedance: 1 k ohm
- Recommended Load Impedance: 10 k ohms or greater
- Bypass: Buffered bypass
- Controls: MODE knob, RATE knob, DEPTH knob, RES (Resonance)/MANUAL knob, Pedal switch
- Indicator: CHECK indicator (Used for indication of check battery)
- Connectors: GUITAR IN jack: 1/4-inch phone type, BASS IN jack: 1/4-inch phone type, OUTPUT A (MONO) jack: 1/4-inch phone type, OUTPUT B jack: 1/4-inch phone type, DC IN jack
- Power Supply: Carbon-zinc battery (9 V, 6F22) or Alkaline battery (9 V, 6LR61), AC adaptor (PSA series: sold separately)
- Current Draw: 40 mA
- Expected battery life under continuous use: Carbon: Approx. 3 hours; Alkaline: Approx. 10 hours *These figures will vary depending on the actual conditions of use.
- Accessories: Owner's manual, Leaflet ("USING THE UNIT SAFELY," "IMPORTANT NOTES," and "Information"), Carbon-zinc battery (9 V, 6F22), Options (sold separately): AC adaptor: PSA series
Size & Weight
- Width: 73 mm (2-7/8 inches)
- Depth: 129 mm (5-1/8 inches)
- Height: 59 mm (2-3/8 inches)
- Weight (including battery): 435 g (1 lb)
* 0 dBu = 0.775 Vrms.
* The specifications are subject to change without notice.
